DSBC-32-40-PPVA-N3T1 1463250 ISO 15552 Festo Pneumatic Cylinder

DSBC-32-40-PPVA-N3T1 1463250 ISO 15552 Festo Pneumatic Cylinder

FESTO DSBC-32-40 is an industrial Pneumatic Cylinder for automation and equipment control applications. It is also commonly referenced with compatible model code PPVA-N3T1, N3T1, 1463250, 15552.

Key Features

• DSBC-32-40-PPVA-N3T1 1463250 ISO 15552 Festo Pneumatic Cylinder is suitable for equipment that needs a matched cylinder or actuator replacement.

• Prepared for checking installation length, rod arrangement, cushioning and working pressure against the original part.

• Helps maintenance teams plan spare parts for repeatable linear motion in automated machinery.

Technical Data

Installation Reminder

Before installation, the machine should be placed in a safe condition according to site procedure, including disconnecting power, air supply or pressure source when required. During fitting, pay attention to interface direction, fixed position, seal placement and connection tightness. After installation, start with low-speed, low-pressure or no-load testing before returning the equipment to normal operation.

After-Replacement Testing

After replacement, it is better not to return the machine directly to continuous production. Start testing in manual, low-speed or low-pressure mode and observe whether the action, response, signal, leakage condition and fastening position are normal. When operation becomes stable, the equipment can gradually return to normal working conditions, followed by a short recheck after initial running.

Our Service Advantages

We support global industrial automation spare parts supply and can arrange international shipment by FedEx, UPS, DHL or other suitable express services according to order requirements. For model confirmation, replacement suggestions, photo comparison and basic technical questions, we try to reply within 24 hours. If the customer is not sure whether the part is suitable, old nameplate photos or equipment pictures can be provided for preliminary checking.

Application Notes

DSBC-32-40-PPVA-N3T1 1463250 ISO 15552 Festo Pneumatic Cylinder is intended for industrial equipment maintenance, automation repair and spare part replacement where the exact FESTO model reference is important. When selecting this motion component, compare the model code, installation distance, rod arrangement and working pressure with the original equipment. Check that the available air flow and control valve timing are suitable for the required movement speed. For this specific listing, pay special attention to 6G when comparing it with the installed part. Before ordering or installing model DSBC-32-40, compare the full nameplate information with the existing component, including the listed specification, port or mounting details, electrical data, pressure range and operating environment. During installation, isolate the machine safely, remove pressure or power according to site procedure, and check that seals, fittings, cables and fasteners are clean and correctly seated. After replacement, test the equipment at low speed or low pressure first, then confirm normal operation, leakage condition, response timing and repeatability before returning the machine to continuous production. If cross reference numbers are involved, compare PPVA-N3T1, N3T1, 1463250 with the installed part before ordering.

Specification Overview

Related Products

• ADN-32-80-A-PPS-A 572663 Festo Pneumatic Cylinder

• DFSP-20-15-DS-PA 576076 Festo Pneumatic Cylinder

• ADN-40-50-A-P-A 536296 Festo Air Cylinder

• DGC-8-200-KF-P-A Festo Slide Table Cylinder

• DSBC-125-80-PPSA-N3 1804664 Festo Standards-Based Cylinder