TXP-P2CGNPM Emerson TOPWORX 1/2NPT Position Limit Switch

TXP-P2CGNPM Emerson TOPWORX 1/2NPT Position Limit Switch

Emerson TXP-P2CGNPM is an industrial Position Limit Switch for automation and equipment control applications. It is also commonly referenced with compatible model code TXP-P2CGNPM.

Key Features

• Emerson Position Limit Switch model TXP-P2CGNPM supports automation control points, travel limits and equipment interlocks.

• Designed for product matching where target material, distance and mounting clearance need confirmation.

• Useful as a spare part for reducing downtime in machine sensing and position feedback systems.

Technical Data

Installation Reminder

Before installation, the machine should be placed in a safe condition according to site procedure, including disconnecting power, air supply or pressure source when required. During fitting, pay attention to interface direction, fixed position, seal placement and connection tightness. After installation, start with low-speed, low-pressure or no-load testing before returning the equipment to normal operation.

After-Replacement Testing

After replacement, it is better not to return the machine directly to continuous production. Start testing in manual, low-speed or low-pressure mode and observe whether the action, response, signal, leakage condition and fastening position are normal. When operation becomes stable, the equipment can gradually return to normal working conditions, followed by a short recheck after initial running.

Our Service Advantages

We support global industrial automation spare parts supply and can arrange international shipment by FedEx, UPS, DHL or other suitable express services according to order requirements. For model confirmation, replacement suggestions, photo comparison and basic technical questions, we try to reply within 24 hours. If the customer is not sure whether the part is suitable, old nameplate photos or equipment pictures can be provided for preliminary checking.

Application Notes

TXP-P2CGNPM Emerson TOPWORX 1/2NPT Position Limit Switch is intended for industrial equipment maintenance, automation repair and spare part replacement where the exact Emerson model reference is important. For position feedback or machine interlock use, verify the electrical interface, sensing range, response mode and environmental protection level. Stable mounting and correct wiring are important for repeatable signals in industrial automation systems. For this specific listing, pay special attention to 1/2NPT when comparing it with the installed part. Before ordering or installing model TXP-P2CGNPM, compare the full nameplate information with the existing component, including 1/2NPT, port or mounting details, electrical data, pressure range and operating environment. During installation, isolate the machine safely, remove pressure or power according to site procedure, and check that seals, fittings, cables and fasteners are clean and correctly seated. After replacement, test the equipment at low speed or low pressure first, then confirm normal operation, leakage condition, response timing and repeatability before returning the machine to continuous production. If cross reference numbers are involved, compare TXP-P2CGNPM with the installed part before ordering.

Specification Overview

Related Products

• TVL-E20GNEM Emerson TOPWORX 3/4NPT Position Limit Switch

• TXP-E20GLPM Emerson TOPWORX 1/2NPT Position Limit Switch

• TXP-E20GNPM Emerson TOPWORX 1/2NPT Position Limit Switch

• TXP-L2CGLPM Emerson TOPWORX 1/2NPT Position Limit Switch

• TXP-M21GNPM Emerson TOPWORX 1/2NPT Position Limit Switch